I've been running an Iomega IX4 in my home vSphere lab 24x7 for the past two years and have found it to be a nice reliable NAS device. The StorCenter ix2-200, Cloud Edition — Firmware Version 3.2.10.30101 (see: )is for the ix2's firmware and.

I would suggest trying to connect the NAS directly to your computer with the ethernet cable provided or any cross-over cable. Instructions to Direct Connect to NAS: Unplug the NAS from the router unplug the pc from the router (if the pc is wireless, disable wireless) Using Ethernet Cable, plug the NAS directly into the pc with no other devices attached. Restart the NAS and wait for it to boot COMPLETELY 100% The NAS will request an address from the PC which will be an APIPA address (this is a 169. Address) Open up your Start Menu and type in CMD in the search bar and select the CMD program. Type in 'arp -a' in the cmd prompt The first time you use the arp -a in a cmd prompt, it gives you the 169.x.x.x address of 'The PC' You may have to arp -a twice to get the NAS address. The second time you use the arp -a I will get another APIPA address in the 169.x.x.x address Take the new address and use it in the web browser just like normal to access the device.

If the device is still not reachable, you can try to reset the StorCenter Pro 150d to factory defaults by holding the Power Button down for 12 seconds. Hi Andrew, I tried to reset the storage holding the button.

The storage strarted flashin green to red until it become solid green, but still unrecheable via http (yes to ping). Then, I tried to restore the firmware from CD. I used an image a Lenovo support employee sent to me to flash the firmware, with instruction. I connected the usb cd drive to a usb port on the back and rebooted the storage. It started green/red flash and then it became solid red. Jesus And Mary Chain Darklands Rar File. Reading the userguide it looks like right by the way solid red means also firmware update.

Dl380 G7 Nic Drivers. But now are 4 days the storage is still solid red. I don't think is going well. I think the partition that contains the web application has gone. But I don't know how to repair it. And I don't know where is that partition. Inside the storage or on the disks?

I hope some suggestions. Is this the recovery CD that you used?: I'm wondering if it is not accepting the new hard drive. Did you replace the hard drive with the same type of hard drive? Is it the same manufacturer, rotational speed, and capacity as the others? There might also be an issue with the power supply, but I don't think this would be the case. One thing you can do is check the power supply voltage selector on the back of the unit just below where the power cable plugs into the server. In North America the switch needs to be set to 115.

If it is set to 230 and you live in North America, power off the unit, flip the voltage switch over to 115, then power on the unit again. After about 45 seconds the top LED should switch from red to green once the server is booted. You can also try using another outlet. If it continues to have issues, I would recommend contacting technical support for further assistance. Hi, i try to rebuild my StorcenterPro 150d after a hdd crash.

Does anyone have an idea where i can get or download the Iomega Recovery CD image? Current Status: I have the old firmware v69.69 and v85.85, but at the time no solution, how to flash the NAS by USB. The four replaced disks are without any firmware on board. I copied the first xfs partition of the crashed hdd with the IomPkgInstDir nas150d_pkd.tar file. The Europe support center gives no longer any support for this storage.